Danfoss VLT AutomationDrive FC 360 Programming Guide

Programming Guide | VLT® AutomationDrive FC 360
Contents
Contents
1 Introduction
1.1 Purpose of this Programming Guide 9
1.2 Additional Resources 9
1.3 Document and Software Version 9
1.4 Approvals and Certifications 9
1.5 Electrical Wiring - Control Cables 10
1.5.1 Overview 10
1.5.2 Start/Stop 12
1.5.3 Latched Start/Stop Inverse 13
1.5.4 Speed Up/Down 14
1.5.5 Potentiometer Reference 14
2 Safety
2.1 Safety Symbols 16
2.2 Qualified Personnel 16
2.3 Safety Precautions 17
3 Programming
3.1 Local Control Panel Operations 20
3.1.1 Local Control Panel (LCP) 20
3.1.2 Quick Menu 22
3.1.3 Status Menu 23
3.1.4 Main Menu 24
3.1.5 Backing Up/Downloading Parameters with LCP 28
3.1.6 Restoring Default Settings with LCP 28
3.1.6.1 Overview 28
3.1.6.2 Recommended Initialization 29
3.1.6.3 Manual Initialization 29
3.2 Basic Programming 29
3.2.1 Asynchronous Motor Setup 29
3.2.2 PM Motor Set-up in VVC+ 29
3.2.2.1 Initial Programming Steps 29
3.2.2.2 Programming Motor Data 30
3.2.2.3 Testing Motor Operation 30
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | i

Danfoss VLT AutomationDrive FC 360 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 360
Category	DC Drives
Language	English