Danfoss VLT AutomationDrive FC 360

Programming Guide | VLT® AutomationDrive FC 360
12
18 19
e30bv181.10
3229
27 31 33 20
P 5-12 [0] P 5-10 [8]
Start/Stop
+ 24V
Speed
Start
Terminal 18
Figure 5: Start/Stop
1.5.3 Latched Start/Stop Inverse
 NOTICE
Make sure the drive is under the factory setting before doing the following operation.
Terminal 18 = Parameter 5-10 Terminal 18 Digital Input[9] Latched start.
Terminal 27 = Parameter 5-12 Terminal 27 Digital Input[6] Stop inverse.
e30bv182.10
Speed
Latched start
Terminal 18
Stop inverse
Terminal 27
12
18
19 322927 31 33 20
P 5-12 [6]
P 5-10 [9] + 24V
Latched
start
Stop
inverse
Figure 6: Latched Start/Stop Inverse
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | 13