Danfoss VLT AutomationDrive FC 360 Programming Guide

4.14 Parameter Group 15-** Drive Information
4.14.1 15-0* Operating Data
15-00 Operating hours
Default value: 0 h Parameter type: Range (0–2147483647 h)
Setup: 1 setup Conversion index: 0
Data type: Uint32 Change during operation: True
View how many hours the drive has run. The value is saved when the drive is turned off.
15-01 Running Hours
Default value: 0 h Parameter type: Range (0–2147483647 h)
Setup: 1 setup Conversion index: 0
Data type: Uint32 Change during operation: True
View how many hours the motor has run. Reset the counter in parameter 15-07 Reset Running Hours Counter. The value is saved when
the drive is turned off.
15-02 kWh Counter
Default value: 0 kWh Parameter type: Range (0–2147483647 kWh)
Setup: 1 setup Conversion index: 0
Data type: Uint32 Change during operation: True
View the output power of the DC bus in kWh as a average value over 1 hour. Reset the counter in parameter 15-06 Reset kWh Counter.
15-03 Power Up's
Default value: 0 Parameter type: Range (0–2147483647)
Setup: 1 setup Conversion index: 0
Data type: Uint32 Change during operation: True
View the number of times the drive has been powered up.
15-04 Over Temp's
Default value: 0 Parameter type: Range (0–65535)
Setup: 1 setup Conversion index: 0
Data type: Uint16 Change during operation: True
View the number of drive temperature faults.
15-05 Over Volt's
Default value: 0 Parameter type: Range (0–65535)
Setup: 1 setup Conversion index: 0
248 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360

Danfoss VLT AutomationDrive FC 360 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 360
Category	DC Drives
Language	English