Danfoss VLT AutomationDrive FC 360

Programming Guide | VLT® AutomationDrive FC 360
View the warning word 2 sent via the serial communication port in hex code.
16-94 Ext. Status Word
Default value: 0 Parameter type: Range (0–0xFFFFFFFFUL)
Setup: 1 setup Conversion index: 0
Data type: Uint32 Change during operation: True
Show the extended status word in hex code.
16-95 Ext. Status Word 2
Default value: 0 Parameter type: Range (0–0xFFFFFFFFUL)
Setup: 1 setup Conversion index: 0
Data type: Uint32 Change during operation: True
Show the extended status word 2 in hex code.
16-97 Alarm Word 3
Default value: 0 Parameter type: Range (0–0xFFFFFFFFUL)
Setup: 1 setup Conversion index: 0
Data type: Uint32 Change during operation: True
View the alarm word 3 sent via the serial communication port in hex code.
4.16 Parameter Group 17-** Feedback Options
4.16.1 17-0* Encoder Interface
 NOTICE
This parameter group is only valid when VLT
®
Encoder Input MCB 102 is installed.
17-00 Encoders Connected
Default value: [0] One Encoder Parameter type: Option
Setup: All setups Conversion index: –
Data type: Uint8 Change during operation: False
Select 1 or 2 encoders connected.
Option Name
[0] One Encoder
[1] Two Encoders
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | 265