Danfoss VLT AutomationDrive FC 360 Programming Guide

Enter the maximum reference. The maximum reference is the highest value obtainable by summing all references. The maximum
reference unit matches:
l The option selected in parameter 1-00 Configuration Mode.
l The unit selected in parameter 3-00 Reference Range.
3-04 Reference Function
Default value: [0] Sum Parameter type: Option
Setup: All setups Conversion index: –
Data type: Uint8 Change during operation: True
Select the reference function.
Option Name Description
[0] Sum Sum both external and preset reference
sources.
[1] External/Preset Use either the preset or the external
reference source. Shift between external
and preset via a command or a digital
input.
4.4.2 3-1* References
Parameters for setting up the reference sources.
3-10 Preset Reference
Default value: 0.00% Parameter type: Range (-100.00–100.00%),
Array [8]
Setup: All setups Conversion index: -2
Data type: Int16 Change during operation: True
Enter up to 8 different preset references (0–7) in this parameter, using array programming. For selecting dedicated references, select
preset reference bit 0/1/2 [16], [17], or [18] for the corresponding digital inputs in parameter group 5-1* Digital Inputs.
Table 14: Preset Referenece Bits
Preset ref. bit 2 1 0
Preset ref. 0 0 0 0
Preset ref. 1 0 0 1
Preset ref. 2 0 1 0
Preset ref. 3 0 1 1
Preset ref. 4 1 0 0
Preset ref. 5 1 0 1
88 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360

Danfoss VLT AutomationDrive FC 360 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 360
Category	DC Drives
Language	English