Danfoss VLT AutomationDrive FC 360

Programming Guide | VLT® AutomationDrive FC 360
34-09 PCD 9 Write For Application
Default value: 0 Parameter type: Range (0–65535)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
Value received in PCD9 of fieldbus telegram.
34-10 PCD 10 Write For Application
Default value: 0 Parameter type: Range (0–65535)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
Value received in PCD10 of fieldbus telegram.
4.23.2 34-2* PCD Read Par.
Parameters for readout of fieldbus data sent to the fieldbus master.
34-21 PCD 1 Read For Application
Default value: 0 Parameter type: Range (0–65535)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
Value sent in PCD1 of fieldbus telegram.
34-22 PCD 2 Read For Application
Default value: 0 Parameter type: Range (0–65535)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
Value sent in PCD2 of fieldbus telegram.
34-23 PCD 3 Read For Application
Default value: 0 Parameter type: Range (0–65535)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
Value sent in PCD3 of fieldbus telegram.
34-24 PCD 4 Read For Application
Default value: 0 Parameter type: Range (0–65535)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | 291