Data type: OctStr Change during operation: True
Configure the IP subnet mask of the option. Read-only if parameter 12-00 IP Address Assignment is set to [1] DHCP or [2] BOOTP.
12-03 Default Gateway
Default value: 0 Parameter type: Range (0–4294967295)
Setup: 1 setup Conversion index: 0
Data type: OctStr Change during operation: True
Configure the IP default gateway of the option. Read-only if parameter 12-00 IP Address Assignment is set to [1] DHCP or [2] BOOTP.
12-04 DHCP Server
Default value: 0 Parameter type: Range (0–2147483647)
Setup: 1 setup Conversion index: 0
Data type: OctStr Change during operation: True
Read-only. Shows the IP address of the found DHCP or BOOTP server.
NOTICE
A power cycle is necessary after setting the IP parameters manually.
12-05 Lease Expires
Default value: 0 Parameter type: Range (0–4294967295)
Setup: All setups Conversion index: 0
Data type: TimD Change during operation: True
Read-only. Shows the lease time left for the current DHCP-assigned IP address.
12-06 Name Servers
Default value: 0 Parameter type: Range (0–4294967295), Array
[2]
Setup: 1 setup Conversion index: 0
Data type: OctStr Change during operation: True
IP addresses of domain name servers. Can be automatically assigned when using DHCP.
12-07 Domain Name
Default value: 0 Parameter type: Range (1–48)
Setup: 1 setup Conversion index: 0
Data type: VisStr Change during operation: True
Domain name of the attached network. Can be automatically assigned when using DHCP network.
204 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360
To Next Page
Loading...
