Danfoss VLT AutomationDrive FC 360

To Next Page

To Previous Page

14-30 Current Lim Ctrl, Proportional Gain

Default value: 100% Parameter type: Range (0–500%)

Setup: All setups Conversion index: 0

Data type: Uint16 Change during operation: True

Enter the proportional gain value for the current limit controller. Selection of a high value makes the controller react faster. Too high a

setting leads to controller instability.

14-31 Current Lim Ctrl, Integration Time

Default value: Size related Parameter type: Range (0.002–2 s)

Setup: All setups Conversion index: -3

Data type: Uint16 Change during operation: True

Control the current limit control integration time. Setting it to a lower value makes it react faster. A setting too low leads to control

instability.

14-32 Current Lim Ctrl, Filter Time

Default value: 5.0 ms Parameter type: Range (1.0–100.0 ms)

Setup: All setups Conversion index: -1

Data type: Uint16 Change during operation: True

Set a time constant for the current limit controller low-pass filter.

14-34 Stall Protection Adjustment Factor

Default value: 100% Parameter type: Range (50%–200%)

Setup: All setups Conversion index: 0

Data type: Uint8 Change during operation: True

Define the stall protection adjustment factor.

14-35 Stall Protection

Default value: [1] Enabled Parameter type: Option

Setup: All setups Conversion index: –

Data type: Uint8 Change during operation: False

Enable or disable the stall protection function.

Option Name Description

[0] Disabled Disable the stall protection function.

[1] Enabled Enable the stall protection when field

weakening mode and Flux mode are

active.

Programming Guide | VLT® AutomationDrive FC 360

Other manuals for Danfoss VLT AutomationDrive FC 360