Danfoss VLT AutomationDrive FC 360

Data type: Uint8 Change during operation: False
Select Dynamic mode to run Speed and Position controller at the control time, which is 143~us to 500~us depending on switching
frequency.
Option Name
[0] Off
[1] On
40-56 Rotor Position Estimation Gain
Default value: 100% Parameter type: Range (10%–100%)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
Set the rotor position estimation gain.
40-57 Low Speed Flux Compensation Gain
Default value: 100% Parameter type: Range (1%–200%)
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
Set the low speed flux compensation gain.
304 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360