Dionex As - Editing a Method; Deleting a Method; Copying a Method; D.5.6 Editing a Method

D • Front Panel Control
Doc. 065051-03 1/08 297
D.5.6 Editing a Method
After creating a method, you can modify it by changing, adding, or
deleting steps and parameters. These changes can be made at any time. If
the method you are editing is currently running, changes made to steps
that have not yet been completed are performed in the current run.
Changes made to steps that have already been completed are performed
the next time the method runs.
1. Go to the
METHOD MENU screen (press Menu and 3).
2. In the
EDIT field, enter the number of the method to be edited.
3. Go to the method screen to be changed and edit the parameters as
required.
4. Save the method (see Section D.5.2
). The changes can be saved to the
same method number or to a new (unused) method number. If you
save to a new number, the original method remains unchanged.
D.5.7 Deleting a Method
1. Go to the METHOD MENU screen (press Menu and 3).
2. Position the cursor in the
EDIT field and press Delete.
A confirmation message appears.
3. Press
Delete again to delete the method.
D.5.8 Copying a Method
1. Go to the METHOD MENU screen (press Menu and 3).
2. Position the cursor in the
EDIT field and enter the number of the
existing method to be copied.
3. Position the cursor in the
SAVE TO field and enter a new (unused)
method number.
4. Press
Enter.
The parameters from the original method are copied to the new
method and the original method is unchanged.