Dionex As - Sample Temperature Control Option

AS Autosampler Operator’s Manual
22 Doc. 065051-03 1/08
2.3.7 Sample Temperature Control Option
The sample temperature control option provides heating and cooling of
the sample tray. You can program the temperature set point from 4
°C to
60
°C. Samples in the tray are uniformly heated or cooled to the
programmed set point (to a minimum of 20
°C below ambient and a
maximum of 40
°C above ambient). The absolute range is 4 °C to 60 °C.
The sample temperature control option sits on the workbench below the
autosampler compartment (see Figure 2-9
).
NOTE The temperature inside the autosampler compartment
may exceed ambient by up to 2 °C. The sample
temperature control option is recommended for samples
that are temperature sensitive.
Figure 2-9. AS with Sample Temperature Control Option
Sample
Temperature
Control Option