EDM Solution 862 - Page 100

100
Solution 862
Installation Manual
How To Program The Telco Disarming Sequence – Easy Call Forward (Immediate Off)
1.
Enter your
followed by
3
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Press button
2
followed by the button to change the telco disarming sequence.
Three beeps will be heard.
If a previous telco disarming sequence has already been programmed, the sequence will
be displayed one digit at a time via the remote codepad indicators. Refer to “Table 39:
Codepad Indicators For Changing Telco Arm/Disarm Sequence” on page 96 for the
indicators and their meanings.
If no telco disarming sequence has been programmed, a further two beeps will be heard
after entering this mode. These two beeps are normally heard after the last digit of the
call forward sequence has been displayed.
3.
Enter
221 2
and the button.
Two beeps will be heard and the system will return to the disarmed state.
+
3
+
2
+
221 2
+
How To Disable The Telco Disarming Sequence
If at any time you wish to cancel the telco disarming sequence, you may enter your
followed by
3
and the button, followed by
2
and the button,
then the
button followed by the
4
and the button.
+
3
+ +
2
+
+ +
4
+
ISSUE130 Electronics Design and Manufacturing Pty Limited