28
Remote Control 1
29
Remote Control 2
2
Remote Control 3
These outputs can be remotely activated (Turned "On" or "Off") via the following
methods:
1.
Remote Codepad - Refer to the Master Code Functions - Turning Outputs
On/Off on page 102 for further information.
2.
Remotely Via Alarm Link Software - Refer to your Alarm Link Instruction
Manual for further information.
2
Radio Control Output 1
This output will operate when the button marked DOOR on the 4 channel hand held
transmitter is activated when the system is armed or disarmed.
2
Radio Control Output 2
This output will operate when the button marked AUX on the 4 channel hand held
transmitter is activated when the system is armed or disarmed.
2
Radio Control Output 1 – Not In AWAY Mode
This output will operate when the button marked DOOR on the 4 channel hand held
transmitter is activated when the system is disarmed or armed in STAY Mode 1 or
STAY Mode 2. The output will not operate when the system is armed in AWAY
Mode
2
Radio Control Output 2 – Not In AWAY Mode
This output will operate when the button marked AUX on the 4 channel hand held
transmitter is activated when the system is disarmed or armed in STAY Mode 1 or
STAY Mode 2. The output will not operate when the system is armed in AWAY
Mode.
2
Communications Failure After 3 Unsuccessful Calls
This output will operate when the communication dialler has made 3 unsuccessful
calls to the base station receiver. he output will reset when all messages have been
transmitted (i.e. When the buffer is empty or when all possible attempts have been
made).
30
Communications Failure
This output will operate when the communication dialler has made all possible
attempts to reach the base station receiver. he output will reset when the first
"Kiss-Off" has been received. This output will not operate for domestic formats.
31
Dialler Disabled
This output will operate as long as Option 1 in "LOCATION 177" on page 145 has
been disabled. The output will reset once Option 1 – Enable Dialler Reporting
Functions in "LOCATION 177" on page 145 has been enabled.
32
Dialler Active
This output will operate when the communication dialler is on-line. he output will
reset when the communication dialler has released the telephone line.
33
Ring Detect
This output will operate when an incoming call has been detected by the control
panel. The output will reset when the ringing has stopped or when the call has been
answered.
Programmable Outputs 197
Electronics Design and Manufacturing Pty Limited ISSUE130
T
T
T
To Next Page
Loading...
