FICEP 32292 - 1.4 LOCATION OF THE MACHINE

SAFETY EQUIPMENT AND REGULATIONS
Page 1-10
1001 DFB
Drilling & Sawing Line
FICEP
1.4 LOCATION OF THE MACHINE
The machine must be installed in a fully covered shop, well protected
against atmospheric agents. The area around the machine must:
- Be dry with a relative humidity factor lower than 85% (not
condensating).
- Have an ambient temperature during the operation:
with forced ventilation
from +5° C to +40° C
- Max. permitted temperature variations
1.1 K/min.
- Max. altitude
1000 m.(a.s.l.) (no restrictions)
2000 m (a.s.l.) 1,5 % power
derating each 100 m exceeding
1000 m
- Storage temperature
From -25° C to +70° C
- Max. storage time
12 months
- The ambient temperature must be:
free from gas, dust, smoke, and any other corrosive or inflammable
particles or matters.
free from flying flashes and/or corrosive metals.