MACHINE SET-UP
1001 DFB
Drilling & Sawing Line
4.3 OPERATION SET - UP
4.3.1 Operation setup by means of the CNC
Every time you change the program (CANONIC PROGRAM) make sure to
perform all the machine set-up operations depending upon the type of
section and the type of work to be carried out.
It is clear that the above set-up operations must comply with the information
coming from the Production and Programming Departments.
The information passed over to the workshop by the Production and
Programming Departments are dependent upon the type of organisation or
automation available, which may vary from shop to shop.
Nevertheless, machine specific information is displayed by the CONTROL
SYSTEM. For detailed information please refer to the programming
chapters of this manual.
4.3.2 Control System SETUP
See Programming Sections.
To Next Page
Loading...