FICEP 32292 - 4.6.4 Solenoids; 4.6.5 Maintenance of the FRL (lubrication filtering and adjusting unit) inlet unit Filter with manual drain; 4.6.6 Lubricator

MACHINE SET-UP
Page 4-30
1001 DFB
Drilling & Sawing Line
FICEP
4.6.4 Solenoids
Keep the relays contacts absolutely clean.
Dirty contacts may originate problems in the power supply producing
humidity and heat of the solenoid coating.
If the ambient temperature exceeds 49° C or the humidity is too high, make
sure to use appropriate solenoid valves.
4.6.5 Maintenance of the "FRL" (lubrication filtering and adjusting
unit) inlet unit Filter with manual drain
Remove the filtering element at regular intervals and wash it with Kerosene.
After the washing, blow compressed air on it.
4.6.6 Lubricator
Keep the cup filled-up with oil to insure an efficient lubrication.
Clean with Kerosene the adjusting unit at regular intervals.
After the washing operation, make sure to blow compressed air to dry it.