MACHINE SET-UP
1001 DFB
Drilling & Sawing Line
4.4.5 Maintenance to be performed during oil replacement
After all the oil is removed from the reservoir and from the hydraulic
system, it is recommended to:
thoroughly clean the reservoir and remove all the sediments that may have
accumulated within the same.
We suggest to filter the oil, either when a partial or total filling is required,
especially in the event of previously opened cans.
4.4.6 How to bleed the air from the circuit
Before starting-up the machine, bleed all the air that might have entered the
circuit and make sure that there is no leaking from the serviced points.
An additional air bleeding cycle is required after the system has reached the
max. temperature, as air formation is produced by the rising temperature.
4.4.7 Filters and their maintenance
Except at the initial start-up phase, the immersed filter must be inspected
every time you replace the oil whereas the external filters (if any) must be
inspected once every month.
To Next Page
Loading...