FICEP 32292 - 4.3.3 Typical SETUP sequence by means of the CNC

MACHINE SET-UP
Page 4-8
1001 DFB
Drilling & Sawing Line
FICEP
4.3.3 Typical SETUP sequence by means of the CNC
- In this Chapter we shall describe a typical operational sequence to be performed by the
operator to SETUP the machine every time a new CANONIC PROGRAM is
processed.
- We shall call CANONIC PROGRAM the program performed on a section, having
variable length, which involves the processing of a part.
- For every CANONIC PROGRAM the operator will normally have a display listing all
the necessary parameters for the SETUP operations.
(See Programming Sections)
- MAKE SURE to have the hydraulic power unit ON, the CNC active and the zeroing
cycle processed when performing the following operations.
- During all SETUP sequences, make sure to have the 3-positions key selector to
SETUP position so as to insure safe working conditions and the activation of all
SETUP selectors.