MACHINE SET-UP
1001 DFB
Drilling & Sawing Line
4.6.1 Supply line
The shop compressed air must reach the pneumatic system inlet assembly,
located on the power unit, free from water or condensate.
Should this condition fail to exist, the pneumatic components, such as
solenoid valves, pressure adjusting valves, etc., will be heavily affected.
The inlet unit, located at the machine system entry side, consists of a filter,
of a lubricator and of a pressure adjusting valve complete with a pressure
gauge.
The purpose of the filter is to eliminate the water and the impurities existing
in the pneumatic system, you are therefore required to check and clean the
filter accurately at regular intervals.
The lubricator is provided to supply the oil to the system either under low or
high air flow.
An adequate lubrication is attained when all the system mobile parts receive
a sufficient quantity of oil thus insuring a high grade of lubrication.
This is essential to insure a long operating life to the system.
We are giving you here below a list of the most appropriate lubricants for
the pneumatic circuitry:
To Next Page
Loading...