FICEP 32292 - 3.2.3 Description of the tool change magazine auxiliary push button station Fig. 2.1216

CONTROLS
Page 3-14
1001 DFB
Drilling & Sawing Line
FICEP
3.2.3 Description of the tool change magazine auxiliary push button
station Fig. 2.1216
a) Selector switch for tool magazine selection : Turret TB - Turret TA (optional). The
following commands are activated for the selected turret.
b) Turret activation to approach the spindle
c) Turret disactivation out of the spindle (retraction)
d) Push button to activate head rotation unlocking
e) Push button to activate spindle rotation unlocking
Note: one only motor operates the head or spindle rotation (depending if it is pin
locked the spindle or the head rotation respectively).
f) Tool release in the spindle
g) Push button to activate manual lube cooling
h) Red mushroom type push button, with mechanical re-set, for global emergency STOP.
Same function as the main emergency stop on CNC.) .
All the above push buttons are active in setup mode.
Push button g) may be used to adjust manually the position of the water jet when
external lubrication has to be used, especially when the drill bit in the spindle has been
changed and most likely the length of the drill bit has changed too.