MACHINE SET-UP
1001 DFB
Drilling & Sawing Line
4.6.7 Lube-cooling of the drill
The machine is supplied complete with a pneumatic system for the lubrication and
cooling of the drill.
4.6.8 Cleaning operations
When cleaning/maintenance operations are required, before getting near the
machine, we recommend always to switch the machine off by opening the main
breaker of the electric board.
Every three weeks
It is recommended to remove the covers from the machine to perform the cleaning
of filters placed on the air intake of:
- the electric board placed on the machine
- the electric board placed on the carriage.
To remove the filter it is necessary to remove the plastic protecting air grating (no
need to open the electric panels).
Every three weeks
It is necessary to clean the filters on the air intake of:
- the CNC box
- the saw panel
- the main electric board.
All the above filters are directly accessible.
To Next Page
Loading...