MACHINE SET-UP
1001 DFB
Drilling & Sawing Line
I M P O R T A N T
During the set-up procedure make sure to comply with the following
operational sequences to prevent accidental activation of any control and to
insure operator's max. safeguard:
apply power to the system and perform the zeroing cycles
rotate the key type selector switch of the machine operative modes in
set-up position.
WE STRONGLY RECOMMEND TO HAVE ALL SET-UP
OPERATIONS CARRIED OUT BY THE MACHINE OPERATOR.
(See introduction Part ANTI-HAZARD AND SAFETY AT WORK
STANDARDS)
To Next Page
Loading...