Model 1001 DFB Programming and operating manual
FICEP S.p.A. 73
The nest is to be saved in the
“Bars list”
A window with the number of required bars opens;
the operator must confirm pressing “OK” or reject
pressing “Cancel” or, maybe, decrease the number of
bars if the total quantity is not available in the factory
storehouse.
If needed the operator can de-
fine a new length for the bars to
use, press OK to re-execute the
nesting procedure for remaining
pieces till zone n. 19 is empty.
When the zone n. 19 is empty all pieces are “ar-
ranged” in bars of material; the operator can close the
nesting windows pressing “ESC” to come back to
general programming window.
The operator can check or execute the nesting car-
ried out.
To Next Page
Loading...