11.3 IEC 61850 Protocol 230
11.4 Read-Only Settings 230
11.5 Read-Only DDB Signals 230
12 Time Synchronisation 231
13 Demodulated IRIG-B 232
13.1 IRIG-B Implementation 232
14 SNTP 233
15 Time Synchronsiation using the Communication Protocols 234
16 Communication Settings 235
Chapter 8 Redundant Ethernet 239
1 Chapter Overview 241
2 Board Versions 242
3 Board Connections 243
4 Redundancy Protocols 244
4.1 Parallel Redundancy Protocol (PRP) 244
4.1.1 PRP Networks 244
4.1.2 Network Elements 244
4.2 Rapid Spanning Tree Protocol (RSTP) 246
4.3 Self-Healing Protocol (SHP) 247
4.4 Dual-Homing Protocol (DHP) 249
5 Generic Functions for Redundant Ethernet Boards 252
5.1 Forwarding 252
5.1.1 Priority Tagging 252
5.2 Simple Network Management Protocol (SNMP) 252
5.3 SNMP MIB Structure for RSTP, DHP and SHP 253
5.4 SNMP MIB Structure for PRP 254
5.5 Simple Network Time Protocol (SNTP) 257
6 Configuring IP Addresses 258
6.1 Configuring the IED IP Address 258
6.2 Configuring the Board IP Address 258
6.2.1 Configuring the First Two Octets of the Board IP Address 259
6.2.2 Configuring the Third Octet of the Board IP Address 259
6.2.3 Configuring the Last Octet of the Board IP Address 259
7 PRP Configurator 262
7.1 Connecting the IED to a PC 262
7.2 Installing the Configurator 262
7.3 Starting the Configurator 263
7.4 PRP Device Identification 263
7.5 PRP IP Address Configuration 263
7.6 SNTP IP Address Configuration 263
7.7 Check for Connected Equipment 263
7.8 PRP Configuration 264
7.9 Filtering Database 264
7.10 End of Session 264
8 RSTP Configurator 265
8.1 Connecting the IED to a PC 265
8.2 Installing the Configurator 265
8.3 Starting the Configurator 266
8.4 RSTP Device Identification 266
8.5 RSTP IP Address Configuration 266
8.6 SNTP IP Address Configuration 266
8.7 Check for Connected Equipment 267
8.8 RSTP Configuration 267
8.8.1 Bridge parameters 267
8.8.2 Port Parameters 267
Contents MiCOM P747
vi P747-TM-EN-1
To Next Page
Loading...
