GE Multilin F650 - Page 496

GE Multilin F650 Digital Bay Controller F-5
APPENDIX F F.1 FACTORY DEFAULT CONFIGURATION
F
PRODUCT SETUP > MODBUS USER MAP
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Address 00 for Modbus user map Address 00 0 N/A [0000 : FFFF]
Address 01 for Modbus user map Address 01 0 N/A [0000 : FFFF]
... ... ...
Address 254 for Modbus user map Address 254 0 N/A [0000 : FFFF]
Address 255 for Modbus user map Address 255 0 N/A [0000 : FFFF]
SETPOINT > PRODUCT SETUP > OSCILLOGRAPHY
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Function Permission Function ENABLED N/A [DISABLED – ENABLED]
Prefault Trigger Position 30 1% [5 : 95]
Samples per cycle Samples/Cycle 64 N/A [4 – 8 – 16 –32 – 64]
Maximum number of oscillos Max. Number Osc. 4 1 oscillo [1 : 20]
Automatic oscillography overwrite Automatic Overwrite DISABLED N/A [DISABLED – ENABLED]
Snapshot Event generation Snapshot Events ENABLED N/A [DISABLED – ENABLED]
SETPOINT > PRODUCT SETUP > DATA LOGGER
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Function permission Function DISABLED N/A [DISABLED – ENABLED]
Data logger Rate Data Logger Rate 1 s N/A
[1 s, 5 min, 10 min, 15 min,
20 min, 30 min, 60 min.]
Data Logger analog channels X Data Logger Chnl X None N/A
SETPOINT > PRODUCT SETUP > DEMAND
SETTING DESCRIPTION NAME DEFAULT VALUE STEP RANGE
USER
VALUE
Function permission Demand Function DISABLED N/A [DISABLED – ENABLED]
Demand method for current values
CRNT Demand
Method
THERMAL
EXPONENTIAL
N/A
[BLOCK INTERVAL -
ROLLING DEMAND -
THERMAL
EXPONENTIAL]
Demand method for Power values
POWER Demand
Method
THERMAL
EXPONENTIAL
N/A
[BLOCK INTERVAL -
ROLLING DEMAND -
THERMAL
EXPONENTIAL]
Demand interval Demand Interval 5 Minutes N/A [5 – 10 – 15 – 20– 30–60]
Trigger Enabled Trigger Enabled DISABLED N/A [DISABLED – ENABLED]
Snapshot Event generation Snapshot Events ENABLED N/A [DISABLED – ENABLED]