D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-93
PRELIMINARY
8-5-3-5 Hard Disk Installation Procedure
NOTE: When replacing the BEP or Hard Disk, one must either obtain new access codes that will fit the
system ID which is programmed on the BEP, or program the BEP system ID to fit the access codes
already registered in the Hard Disk. Only qualified personnel should perform these tasks.
1) To install the hard disk follow the replacement procedure in reverse order as described above.
2) Refit the following covers: front, DVD, right side, left side
3.) Turn ON power to the system.
Note: When a new hard disk arrives from the manufacturer, usually it is partitioned and ready for
software installation. Refer to Operating System and/or Application Software Loading
Procedures on page 8 - 173 for software installation instructions.
• Front Cover Removal Procedure on page 8 - 16
• DVD Cover Removal Procedure on page 8 - 11
• Right Side Cover Removal Procedure on page 8 - 10
• Air Inlet (Left Side) Cover Removal Procedure on page 8 - 7
To Next Page
Loading...
