D
IRECTION FR091521, REVISION 1 VIVID S60N/VIVID S70N BASIC SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-163
PRELIMINARY
6.) Insert the supporting pin, threading it through the brackets and the lower gas spring holder, as
shown in Figure 8-199.
7.) Applying Locktite, insert the first locking screw previously removed and screw it in until it just
touches the supporting pin.
8.) Applying Locktite, return the second screw and tighten firmly - both the screws will now be locked
against the supporting pin.
9) Perform the following installation procedures:
10.)Turn ON power to the system.
11.)
• LCD Arm Alton 21.5in Wide Monitor Installation Procedure on page 8 - 152
• Operator Panel Keyboard Assembly Installation Procedure on page 8 - 47
• OPIO Basket Installation Procedure on page 8 - 26 (if applicable)
• Install the 21.5" Monitor on page 8 - 33
To Next Page
Loading...
Need help?
General
