GW Instek LCR Series User Manual

SAFETY INSTRUCTIONS
7
(Note) EN 61010-1:2010 specifies the measurement
categories and their requirements as follows. The
LCR-8200 Series doesn’t fall under category II, III
or IV.
 Measurement category IV is for measurement
performed at the source of low-voltage
installation.
 Measurement category III is for measurement
performed in the building installation.
 Measurement category II is for measurement
performed on the circuits directly connected to
the low voltage installation.
Power Supply
WARNING
 AC Input voltage: 100-240 VAC 50/60Hz
 The power supply voltage should not fluctuate
more than 10%.
 Connect the protective grounding conductor of
the AC power cord to an earth ground, to avoid
electrical shock.
Cleaning the
Instrument
 Disconnect the power cord before cleaning.
 Use a soft cloth dampened in a solution of mild
detergent and water. Do not spray any liquid.
 Do not use chemicals containing harsh material
such as benzene, toluene, xylene, and acetone.
Operation
Environment
 Location: Indoor, no direct sunlight, dust free,
almost non-conductive pollution (Note below)
 Temperature: 0°C to 40°C
 Humidity:
< 30°C: < 80%RH(non-condensing);
30°C~40°C: <70%RH(non-condensing);
>40°C: <50%RH (non-condensing)
 Altitude: <2000m

GW Instek LCR Series Specifications

General

Brand	GW Instek
Model	LCR Series
Category	Measuring Instruments
Language	English