GW Instek LCR Series User Manual

LCR-8000 Series User Manual
8
(Note) EN 61010-1:2010 specifies the pollution
degrees and their requirements as follows. The
LCR-8200 SERIES falls under degree 2.
 Pollution refers to “addition of foreign matter,
solid, liquid, or gaseous (ionized gases), that
may produce a reduction of dielectric strength
or surface resistivity”.
 Pollution degree 1: No pollution or only dry,
non-conductive pollution occurs. The pollution
has no influence.
 Pollution degree 2: Normally only non-
conductive pollution occurs. Occasionally,
however, a temporary conductivity caused by
condensation must be expected.
 Pollution degree 3: Conductive pollution occurs,
or dry, non-conductive pollution occurs which
becomes conductive due to condensation which
is expected. In such conditions, equipment is
normally protected against exposure to direct
sunlight, precipitation, and full wind pressure,
but neither temperature nor humidity is
controlled.
Storage
environment
 Location: Indoor
 Temperature: -10°C to 70°C
 Humidity: <80%RH(non-condensing)
Disposal
Do not dispose this instrument as unsorted
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased. Please make sure
discarded electrical waste is properly recycled to
reduce environmental impact.

GW Instek LCR Series Specifications

General

Brand	GW Instek
Model	LCR Series
Category	Measuring Instruments
Language	English