155
────────────────────────────────────────────────────
10.4 Operating Procedure
────────────────────────────────────────────────────
NOTE
CAUTIO
Using the printer in a high-temperature or high-humidity environment should be
avoided at all costs. This can seriously reduce the printer life.
Reference Printing time
Because one roll of 1196 Printing Paper is 25 meters long, it is possible to
calculate the length of time that measurement and printing can continue by
calculating the length of one printout of data.
For example, when printing all items for a three-phase, four-wire line in
"Integrated Measurement" mode, one printout of data requires approximately
360 mm of paper (about 4 mm/line). ((Approximately 193 mm, except for the
maximum and minimum values.) If the interval time is 30 minutes, the
length of time that measurement and printing can continue is calculated as
follows:
Number of printouts: N = 25 m/360 mm = 69 printouts
Continuous operation time: T = interval time x N = 30 minutes x 69
= 2070 minutes = 34 hours and 30 minutes
A red line appears on the last 60 centimeters of the recording paper,
indicating that only a little paper remains.
Special printed output
Just as with the display, "o.r." is printed for out-of-range data, and "−−−−"
is printed for invalid data.
・Because the items that are printed out vary with the measurement mode, set
the items for each mode separately. Note that the data that is output is the
same, whether for manual printing or automatic output.
・Be sure to load enough paper so that the printer will not run out.
・For details on how to print out the setting conditions, refer to the section
entitled, "Printing Out the Settings," in each chapter describing the different
measurement modes and Setting mode.
To Next Page
