Hioki 3166 - Page 199

177
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ Current range setting
Synta
x
CURRent:AUTO data
dat
a
20, 50, 100, 200, 500 (numerical data in NR1 format)
Functio
n
Sets the current range. The units are amps (A).
Erro
r
・In the following circumstances, a device dependent error is generated:
If this command is executed in the HOLD state .
If an attempt was made to execute this command while waiting for or
executing integrated measurement or demand measurement.
In the event of a system error.
・If the value other than setting 20, 50, 100, 200, 500 limits are set, an
execution error is generated.
Exampl
e
Transmission
":CURR:RANG 50"
Sets to 50 A range.
■ Current range setting query
Synta
x
CURRent:RANGe?
Functio
n
Returns the presently set current range as a numerical value (data) in NR1
format.
Respons
e
synta
x
If headers are ON
If headers are OFF
":CURRENT:RANGE data"
"data"
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":CURR:RANG?"
":CURRENT:RANGE 20"
":CURR:RANG?"
"20"
C
URRent:RANGe
C
URRent:RANGe?