Hioki 3166 - Page 202

180
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ Demand measurement FD automatic output setting
Synta
x
DEMand:DATAout:FD data
dat
a
ON, OFF (character data)
Functio
n
Sets Demand measurement mode FD automatic to either "ON" or "OFF".
Not
e
If there is no FDD unit connected, if there is no floppy disk loaded in the
drive, if an existing file name is being used, or if the disk is write-protected
,
this command itself ends normally, but the first attempt to execute
automatic output will generate an error, and automatic output will not be
executed.
Erro
r
･ If data is set to character data other than "ON" or "OFF", an execution
error is generated.
･ In the following circumstances, a device dependent error is generated:
If an attempt was made to execute this command while waiting for or
during demand measurement.
In the event of a system error.
Exampl
e
Transmission
":DEM:DATA:FD ON"
Demand measurement mode FD automatic setting is turned on.
■ Demand measurement FD automatic output query
Synta
x
DEMand:DATAout:FD?
Functio
n
Returns the current Demand measurement mode FD automatic output
query in (data) as either ON or OFF.
Respons
e
synta
x
If headers are ON
If headers are OFF
":CURRENT:AUTO data"
"data"
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":DEM:DATA:FD?"
":DEMAND:DATAOUT:FD ON"
":DEM:DATA:FD?"
"ON"
D
EMand:DATAout:FD
D
EMand:DATAout:FD?