Hioki 3166 - Page 210

188
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ Transformer capacity setting
Synta
x
DEMand:TRANs data
dat
a
0 to 1000000 (numerical data in NR1 format)
Functio
n
・Sets the transformer capacity. The unit is " VA".
・Although values in NRf format are accepted in (data).
Not
e
If the transformer capacity is set to "0", the TLF calculation is not made.
Erro
r
An execution error results if an attempt was made to set a value outside of
the range indicated above.
Exampl
e
Transmission
":DEM:TRAN 3000"
Sets the transformer capacity to 3 kVA.
■ Transformer capacity query
Synta
x
DEMand:TRANs?
Functio
n
Returns the transformer capacity setting by means of NR3 numeric data
(data).
Respons
e
synta
x
If headers are ON
If headers are OFF
":DEMAND data"
"data"
data
+1.2345E+03 (numerical data in NR3) format
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":DEM:TRAN?"
":DEMAND:TRANS +1.2345E+03"
":DEM:TRAN?"
"+1.2345E+03"
D
EMand:TRANs
D
EMand:TRANs?