Hioki 3166 - Page 209

187
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ Demand time setting
Synta
x
DEMand:TIME data
dat
a
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10 (numerical data in NR1 format)
0: 5 minutes 6: 3 hours
1: 10 minutes 7: 4 hours
2: 15 minutes 8: 6 hours
3: 30 minutes 9: 8 hours
4: 1 hour 10: 12 hours
5: 2 hours
Functio
n
Sets the demand measurement time.
Erro
r
・An execution error results if any value other than that indicated above is
set for (data).
・In the following circumstances, a device dependent error is generated:
If an attempt was made to execute this command while waiting for or
during demand measurement.
In the event of a system error.
Exampl
e
Transmission
":DEM:TIME 3"
Sets the demand measurement time to 30 minutes.
■ Demand time query
Synta
x
DEMand:TIME?
Functio
n
Returns the demand period setting.
Respons
e
synta
x
If headers are ON
If headers are OFF
":DEMAND:TIME data"
"data"
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":DEM:TIME?"
":DEMAND:TIME 3"
":DEM:TIME?"
"3"
D
EMand:TIME
D
EMand:TIME?