Hioki 3166 - Page 212

190
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ Demand measurement mode display
Synta
x
DISPlay:DEMand data
dat
a
1 to 16 (numerical data in NR1 format)
1: Instantaneous value
2: Integrated minimum/maximum
3: Integrated 1/2
4: Integrated 2/2
5: Demand minimum/maximum
6: Demand 1/2
7: Demand 2/2
8: Daily report minimum/maximum
9: Daily report 1/2
10:Daily report 2/2
11:Weekly report minimum/maximum
12:Weekly report 1/2
13:Weekly report 2/2
14:Monthly report minimum/maximum
15:Monthly report 1/2
16:Monthly report 2/2
Functio
n
Displays the Demand measurement mode screen.
Not
e
・If this command is executed, the current maximum/minimum value data
and the integrated measurement data are reset.
・If an attempt is made to execute this command while waiting for or during
integrated measurement, a device-dependent error results. Use the STOP
command to release the power meter from the integrating state before
executing this command.
Erro
r
・In the following circumstances, a device dependent error is generated:
If an attempt was made to execute this command while waiting for or
during integrated measurement.
In the event of a system error.
・An execution error results if any value other than that indicated above is
set for (data).
Exampl
e
Transmission
":DISPLAY:DEMAND 1"
Displays the Demand mode "Instantaneous Value" screen.
D
ISPlay:DEMand