Hioki 3166 - Page 245

223
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ Normal measurement FD output file name setting
Synta
x
NORMal:DATAout:FILEname data
dat
a
Character string consisting of up to 8 normal-sized characters
Functio
n
Sets the file name that is used for normal measurement mode FD output.
Not
e
･ The following characters can be used in file names:
Upper-case letters from A to Z
Numbers form 0 to 9
-,^,$,~,!,#,%,&,-,{,},(,),@,’,‘
Shift JIS codes
･ A file extension cannot be specified.
･ If there is no FDD unit connected, if there is no floppy disk loaded in the
drive, if an existing file name is being used, or if the disk is write-protected
,
this command itself ends normally.
Erro
r
･ An execution error results if an attempt was made to use a character that
cannot be used in (data).
･An execution error results if an attempt was made to specify a character
string that consisted of 9 or more characters.
･ In the following circumstances, a device dependent error generated:
In the event of a system error.
Exampl
e
Transmission
":NORM:DATA:FILE TEST"
Sets "TEST" as the file name for normal measurement mode FD output.
■ Normal measurement FD output file name query
Synta
x
NORMal:DATAout:FILEname?
Functio
n
Returns the name of the file used for normal measurement mode FD
output in (data) in the form of a character string.
Respons
e
synta
x
If headers are ON
If headers are OFF
":NORMAL:DATAOUT:FILENAME data"
"data"
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":NORM:DATA:FILE?"
":NORMAL:DATAOUT:FILENAME TEST"
":NORM:DATA:FILE?"
"TEST"
N
ORMal:DATAout:FILEname
N
ORMal:DATAout:FILEname?