Hioki 3166 - Page 250

228
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ CT ratio setting
Synta
x
SCALe:CT data
dat
a
0.01 to 10000.00 (numerical data in NR2 format)
Functio
n
The current value of CT ratio is set.
Not
e
・If this setting is incorrect, correct measurements will not be obtained.
・If data is not in NRf format.
Erro
r
・If the value other than setting limit is set, an execution error is generated.
・If an attempt is made to execute this command while waiting for or
executing integrated measurement or demand measurement, a device-
dependent error results.
Exampl
e
Transmission
":SCAL:CT 1"
The CT ratio is set to 1.
■ CT ratio setting query
Synta
x
SCALe:CT?
Functio
n
The current value of CT ratio is returned as a numerical value (data)in
NR2 numerical format.
Not
e
With this query, if any error occurs, no response message is produced.
Respons
e
synta
x
If headers are ON
If headers are OFF
data
":SCALE:CT data"
"data"
+1.00000E‑02 to +1.00000E+04
(numerical data in NR3 format)
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":SCAL:CT?"
":SCALE:CT +1.00000E+00"
":SCAL:CT?"
"+1.00000E+00"
S
CALe:CT
S
CALe:CT?