Hioki 3166 - Page 251

229
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ PT ratio setting
Synta
x
SCALe:PT data
dat
a
1 to 10000 (numerical value in NR1 format)
Functio
n
･ The current value of PT ratio is set.
Not
e
･ If data is other than character data, a command error is generated.
･ Setting the averaging count.
Erro
r
･ If the value other than setting limit is set, an execution error is generated.
･ If an attempt is made to execute this command while waiting for or
executing integrated measurement or demand measurement, a device-
dependent error results.
Exampl
e
Transmission
":SCAL:PT 1"
The PT ratio is set to 1.
■ PT ratio setting query
Synta
x
SCALe:PT?
Functio
n
The current value of PT ratio is returned as a numerical value (data)in
NR1 numerical format.
Respons
e
synta
x
If headers are ON
If headers are OFF
":SCALE:PT data"
"data"
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":SCAL:PT?"
":SCALE:PT 1"
":SCAL:PT?"
"1"
S
CALe:PT
S
CALe:PT?