272
────────────────────────────────────────────────────
14.5 Saving Measurement Data
────────────────────────────────────────────────────
CAUTIO
・The display of the measured values is not updated while data is being
automatically output. Keys also may not function temporarily while data is
being output.
・If "FD auto output" is set to "ON", the SAVE key has no effect while
integrated or demand measurement is in progress. After measurement ends
(including while integration is in standby), it is possible to change the
print/save items and save the data to a file named "AUTOXXX" by pressing
the SAVE key. However, if the print/save items are changed, additional
integration is no longer possible.
NOTE
CAUTIO
If there is no floppy disk in the 9595 FDD UNIT, an error results and the save
operation is not executed. In addition, note that if the disk becomes full, an
error is displayed and the save operation is not performed.
2. In the case of "Integrated Measurement" mode, set the output interval as well.
3. Begin measurement.
4. At the end of each interval or demand period, the measurement data is
automatically saved to the same floppy disk.
・In the case of "Demand Measurement" mode, there is no output interval
setting.
・For details on how to save the setting conditions, refer to the section entitled
"Saving the Settings to Floppy Disk" for each measurement mode and Setting
mode.
・In the display hold status, data held is saved.
To Next Page
