229
Creating a static ARP entry
1. Select Network > ARP Management from the navigation tree to enter the default ARP Table page
shown in Figure 208.
2. Cli
ck Add.
Figure 209 Adding a static ARP entry
3. Configure the static ARP entry as described in Table 77.
4. Click Apply.
Table 77 Configuration items
Item Descri
IP Address Enter an IP address for the static ARP entry.
MAC Address Enter a MAC address for the static ARP entry.
Advanced
Options
VLAN ID Enter a VLAN ID and specify a port for the static ARP entry.
IMPORTANT:
The VLAN ID must be the ID of the VLAN that has already been created, and the port
must belong to the VLAN. The corresponding VLAN interface must have been created.
Port
Removing ARP entries
1. Select Network > ARP Management from the navigation tree to enter the default ARP Table page
shown in Figure 208.
2. Remov
e ARP entries:
{ To remove specific ARP entries, select the boxes of target ARP entries, and click Del Selected.
{ To remove all static and dynamic ARP entries, click Delete Static and Dynamic.
{ To remove all static ARP entries, click Delete Static.
{ To remove all dynamic ARP entries, click Delete Dynamic.
Configuring gratuitous ARP
1. Select Network > ARP Management from the navigation tree.
To Next Page
Loading...
