Remarks
1. Configuring a time range.
Optional.
Add a time range. A rule referencing a time range takes effect
only during the specified time range.
2. Adding an IPv6 ACL.
Required.
Add an IPv6 ACL. The category of the added IPv6 ACL
depends on the ACL number that you specify.
3. Configuring a rule for a basic IPv6 ACL.
Required.
Complete one of the tasks according to the ACL category.
4. Configuring a rule for an advanced IPv6
ACL.
Configuring a time range
1. Select QoS > Time Range from the navigation tree.
2. Click the Create tab to enter the time range configuration page.
Figure 468 Adding a time range
3. Configure a time range as described in Table 135.
4. Click Apply.
To Next Page
Loading...
Need help?
General