135
Modifying a VLAN interface
By modifying a VLAN interface, you can assign an IPv4 address, an IPv6 link-local address, and an IPv6
site-local address, or global unicast address to the VLAN interface, and shut down or bring up the VLAN
interface.
After you modify the IPv4 address and status or the IPv6 address and status, or add an IPv6 unicast
address for a selected VLAN interface on the page for modifying VLAN interfaces, you must click the
correct Apply button to submit the modification.
After you change the IP address of the VLAN interface you are using to log in to the device, you will be
disconnected from the device. You can use the changed IP address to re-log in.
To modify a VLAN interface:
1. Select Network > VLAN Interface from the navigation tree.
2. Click the Modify tab to enter the page for modifying a VLAN interface.
Figure 133 Modifying a VLAN interface
3. Modify a VLAN interface as described in Table 44.
4. Click Apply.
Table 44 Configuration items
Item Descri
Select VLAN Interface
Select the VLAN interface to be configured.
The VLAN interfaces available for selection in the list are those created on the page
for creating VLAN interfaces.
To Next Page
Loading...
Need help?
General