HP 830 Series - Rate Limit Configuration Procedure; Priority Mapping Table Configuration Procedure; Priority Trust Mode Configuration Procedure; Adding a Class

479
Rate limit configuration procedure
Ste
p
Remarks
1. Configuring rate limit on a port
Required.
Limit the rate of incoming packets or outgoing packets
of a physical port.
Priority mapping table configuration procedure
Ste
p
Remarks
1. Configuring priority mapping tables
Required.
Set priority ma
pping tables.
Priority trust mode configuration procedure
Ste
p
Remarks
1. Configuring priority trust mode on a port
Required.
Set the priority trust mode of a port.
Adding a class
1. Select QoS > Classifier from the navigation tree.
2. Click the Create tab to enter the page for adding a class.
Figure 486 Adding a class