HP 830 Series User Manual

26
Accessing the controller engine from the
switching engine
The controller engine and the switching engine of the switch use independent operating systems, Web
interfaces, and CLI. From the perspective of SNMP, they are different entities. To access each other's
Web interfaces, they must have each other's IP address.
To enable automatic toggling between their Web interfaces, HP already specified the default
management IP address of the switching engine on the controller engine, and specified the default IP
address of the controller engine on the switching engine.
If you are using the default settings, you do not need to perform the task described in "Specifying
management IP addresses at the CLI." If you have changed their management IP addresses, you must
perform the task.
Specifying management IP addresses at the CLI
Ste
p
Command
Remarks
1. Log in to the controller engine.
See login management in HP 830
Series PoE+ Unified Wired-WLAN
Switch and HP 10500/7500 20G
Unified Wired-WLAN Module
Fundamentals Configuration
Guide.
N/A
2. Enter system view of the
controller engine.
system-view N/A
3. Specify the management IP
address of the switching
engine.
oap management-ip ip-address
slot 0
By default, the management IP
address of the switching engine is
192.168.0.101.
4. Return to user view.
quit N/A
5. Log in to the switching engine
from the controller engine.
oap connect slot 0
To return to the controller engine's
CLI, press Ctrl+K.
6. Enter system view of the
switching engine.
system-view N/A
7. Specify the management IP
address of the controller
engine.
oap management-ip ip-address
slot 1
By default, the management IP
address of the controller engine is
192.168.0.100.
IMPORTANT:
A
fter the configuration, make sure the switching engine and controller engine can reach each other.

HP 830 Series Specifications

General

Brand	HP
Model	830 Series
Category	Switch
Language	English