HP 830 Series User Manual

186
Table 61 Configuration items
Item Descri
p
tion
Enter Link Aggregation
Interface ID
Assign an ID to the link aggregation group to be created.
You can view the result in the Summary area at the bottom of the page.
Specify Interface Type
Set the type of the link aggregation interface to be created:
• Static (LACP Disabled)
• Dynamic (LACP Enabled)
Select port(s) for the link
aggregation interface
Select one or multiple ports to be assigned to the link aggregation group from
the chassis front panel.
You can view the result in the Summary area at the bottom of the page.
Displaying information about an aggregate
interface
1. Select Network > Link Aggregation from the navigation tree.
The Summary tab is displayed by default. The list on the upper part of the page displays
information about all the aggregate interfaces.
2. Select an aggregate interface from the list.
The list on the lower part of the page displays the detailed information about the member ports of
the corresponding link aggregation group.
Figure 172 Displaying information about an aggregate interface

HP 830 Series Specifications

General

Brand	HP
Model	830 Series
Category	Switch
Language	English