HP 830 Series - Switching to the Management Level

69
Figure 58 Setting the super password
3. Configure a super password as described in Table 17.
4. Click Apply.
Table 17 Configuration items
Item Descri
p
tion
Create/Remove
Select the operation type:
• Create—Configure or change the super password.
• Remove—Remove the current super password.
Password Set the password for non-management level users to switch to the management level.
Confirm Password
Enter the same password again. Otherwise, the system will prompt that the two
passwords are not consistent when you apply the configuration.
Password
Encryption
Encryption algorithm for the password:
• Reversible—The device uses a reversible encryption algorithm to encrypt the
password before saving it.
• Irreversible—The device uses an irreversible encryption algorithm to encrypt the
password before saving it.
Switching to the management level
This function allows a user to switch from the current user level to the management level. To switch to the
management level, a user must provide the correct super password.
The switchover operation does not change the access level configured for the user. The access level
switchover of a user is only effective for the current login. When the user logs in to the Web interface
again, the access level of the user is still the original level.
To switch to the management level:
1. Select Device > Users from the navigation tree.
2. Click the Switch To Management tab.
3. Enter the correct super password.
4. Click Login.