441
Configuring port isolation
Overview
Usually, Layer 2 traffic isolation is achieved by assigning ports to different VLANs. To save VLAN
resources, port isolation isolates ports within a VLAN, allowing for great flexibility and security.
The device supports multiple isolation groups that can be configured manually.
There is no restriction on the number of ports assigned to an isolation group.
Layer 2 traffic cannot be forwarded between ports in different VLANs. Within the same VLAN, ports in
an isolation group can communicate with those outside the isolation group at Layer 2.
Configuring a port isolation group
Recommended configuration procedure
Ste
1. Adding port isolation groups.
Required.
By default, no port isolation group exists.
2. Configuring member ports for a
port isolation group.
Required.
By default, a port isolation group does not contain an isolated port
when it is created.
You can configure multiple isolated ports for a port isolation group.
Adding port isolation groups
1. Select Security > Port Isolate Group from the navigation tree.
2. Click the Group Setup tab.
To Next Page
Loading...
Need help?
General