3.9 Gateway Parameter Configuration Tool
A3-174
ME0384-4A
(5) Next, set the axis number after adding/deleting.
Select from the following selection items and press "Complete".
Number of Axes
Selection item Axis number setting change results
When adding
Shift
Shifts the axis number of the added drivers from before.
Unallocated number Sets unassigned number to the added driver.
When deleting
Shift
Shifts the axis number of the deleted driver from before.
Keep as reserved unit
Adds the reserved unit after the edited unit and
leaves the axis number.
<When Drv1 is added to Unit1 and "Shift" is selected>
<When Drv1 is added to Unit1 and "Unallocated number" is selected>
To Next Page
Loading...
Need help?
General
