IAI Rcon - Page 427

4.1 How to Use the Gateway Parameter Configuration Tool
B4-6
ME0384-4A
Chapter 4 Network Configuration
Startup Section
When the "Driver of USB conversion
adaptor" screen is displayed, click
.
"IAI Corporation USB to UART Bridge
Controller Driver Installer"
When the screen is displayed, click
.
When the message "The driver was
successfully installed on this computer"
is displayed on the same screen, click
.
3
"Driver of USB conversion adaptor" screen
Click
"IAI Corporation USB to UART Bridge
Controller Driver Installer" screen
Click
Click
4