4.1 How to Use the Gateway Parameter Configuration Tool
B4-14
ME0384-4A
Chapter 4 Network Configuration
[Installing USB Connection Driver for RCON]
It is necessary to install the driver when connecting the PC software or gateway parameter
configuration tool to the USB connector on RCON.
Installation process is explained as shown in the following steps from 1 to 5.
It is not necessary to have the installation work described in this section for Windows 10.
(1) Insert the CD-ROM supplied with
RCM-101-USB into the CD drive of
the PC.
(2) The "Tool for installation" screen
will be displayed.
Click the "Tool for installation" screen
.
Insert CD-ROM
supplied with RCM-101
"Tool for installation" screen
"Tool for installation" screen
To Next Page
Loading...
Need help?
General
